Quick Answer: Can You Shock A Pool More Than Once A Week?

How often should you shock an above ground pool?

every 1-2 weeksAlways make sure that the filter system is running while shocking the pool.

Some pool owners choose to shock their pools once every 1-2 weeks as normal maintenance.

This is a great way to keep your chlorine level up and prevent algae growth..

Why did my pool turn green after I shocked it?

However, the pool may turn green after shocking, which is caused by an increased amount of dissolved copper in the water. This copper can occur naturally in the water or come from copper plumbing that is leeching into the pool.

How often should a pool be shocked?

every weekAs a rule of thumb, you should shock your pool every week, even if you don’t think that it needs it. But, there are several instances when you should certainly shock your pool: Shock your pool when you open it for the season to kill any bacteria or algae. Shock your pool after heavy use or a party.

How many bags of shock do I need for my pool?

The general recommendation is to use 1 pound of cal hypo shock for every 10,000 gallons of pool water, and 10 ounces of sodium hypo with around 12.5% chlorine to sanitize your pool.

How many times can you shock a pool in a week?

Shock at night to give your pool shock the time it needs to do its job. Also, shock your pool once a week, using about 1 lb. (. 5 kg) of shock for every 10,000 gallons (37,854 L) of water, and test until you’re at or near the target of 3 ppm.

Do you leave skimmer basket in when vacuuming pool?

Now, here answers the question earlier: do you leave skimmer basket in when vacuuming pool? YES, you need to remove the skimmer or strainer basket before attaching the open end of the hose to the inlet. Finally, plug the open vacuum hose into the suction port.

Will fire departments fill your pool?

Firefighters can fill up your pool, but they rarely will. Most fire departments don’t have the time to do so. If you contact your local fire department about this be prepared for them to say “no” or to charge a reasonable fee for doing so, this fee will typically be given to charity.

Can you shock a pool too much?

You can, however, use more shock than you need – or less than is sufficient. In other words, while you shouldn’t worry too much about adding a little extra pool shock, there is still a right way and a wrong way to shock your pool if you want to get the best results.

Should I shock my pool when I first fill it up?

The first couple of weeks after starting up your pool is the time to make sure everything is running right. You will need to check your water readings more often in the beginning. … At first you’ll add chlorine in what’s called “shock” levels – an extra heavy dose to start your pool off.

What setting should my filter be on when vacuuming a pool?

For routine vacuuming, the filter valve is left in the normal “Filter” position. This directs dirty vacuum water through the pool filter to remove the contaminants, then conveys filtered water through return lines back to the pool. The “Filter” setting is used for light to moderate levels of pool sediment.

What time of day should I shock my pool?

Sun Down – You’ll want to shock your pool in the evening when the sun has gone down. This gives your pool plenty of time during the night to free the chlorine and clean the water. In the morning, you should be able to enjoy your pool. If you shock your pool during the day, the sun’s UV rays will dissolve the chlorine.

Can you shock a pool two days in a row?

It’s pretty tough to over-shock your pool; shocking your pool two days in a row with the proper dosage for your pool volume shouldn’t be a problem – and in fact, is sometimes even needed to rid your pool of algae and other contaminants.

Do you vacuum a pool on backwash or waste?

You can vacuum a pool on backwash, in theory at least, but it would have no benefit. The water would be pumped backwards through the filter, trapping much of the dirt, before passing out through the backwash hose. This dirt would then end up back in the pool once the pump was back on the filter setting.

What’s the difference between waste and backwash?

Drain/Waste: Opting the drain or waste setting will remove pool water without forcing it through the filter. Backwash: This clears out any debris, dirt and other contaminants that may have accumulated on the filter. Closed: if you choose this setting, then the flow of water to the pool and filter will be stopped.

Is chlorine and shock the same thing?

Chlorine and shock are not the same thing. Shock has a more intense chemical strength than the traditional chlorine sanitizers, and it also differs in how you should apply it to your swimming pool. Short answer: No. Chlorine sanitizers and shock are similar but different in strength.